What You Need to Know About Toilet Plumbing
You may be wondering about the basics of toilet plumbing. Here’s what you need to know. Your water supply line is actually pretty simple. A 1/2-inch copper pipe runs from your house’s 3/4-inch water main to the toilet tank. It then sticks out the wall under the toilet tank, where you connect a compression fitting to the pipe. You can connect this pipe with a wrench. Afterward, you’ll need to connect the stop valve to the water supply line.
Your toilet’s tank holds 1.6 gallons of water, but most manufacturers control the amount of water that flows into the bowl. The tank and bowl contain different components, so it is essential that you know your toilet’s specific requirements. A registered plumbing designer, master plumber, and director of the Kohler Company codes and standards, James Sargeant can help you install a toilet that meets the standards of your home. Listed below are some important things to know about toilet plumbing.
P-traps should be installed in every bathroom drain. These pipes hold a pool of water in an inverted P-shaped pipe to keep sewer gases and creepy crawlies out. Toilet P-traps should also be connected to a vent system on the outside of the building, typically the roof. Your toilet P-trap should be located inside the toilet bowl, where it meets the flange. There is no standard length for the trap arm, so you can extend it to wherever you like.
Besides the P-trap, your toilet should also be connected to a sewer line. The P-trap connects the toilet to the sewer system, and your toilet’s drain pipe will connect to the sewer line. Your toilet’s drain is located below the rough-in, which connects to the city’s sewer system or your septic system. If your toilet doesn’t connect to a sewer line, you need to connect it to a septic tank or a city-owned sewer system.
The main parts of the toilet are the tank, the bowl, and the drain. These parts work together to address the basic human need of sanitation. As a result, the toilet has evolved in both minor and major aspects over the past century. It contains a bowl, which sits at the base of the toilet, and a separate tank, which collects the water from the home’s water supply. Once a person is finished using the toilet, the water fills the tank and sends the waste out of the toilet into sewage pipes.
A plumbing snake is a more serious alternative to a closet auger. The plumbing snake is an electric-powered version of an auger. It is a bit larger than a closet auger, but it has claws on the end for pulling out a stuck object. They are particularly useful when tree roots have lodged in the pipes. However, it’s important to remember that a plunger is not a foolproof method for cleaning a clogged toilet.